MangOH RED SENSORS

jyijyi · July 13, 2018, 11:19am

You can refer to here on how to build the legato image for mangoH Red board:

mangOH/mangOH/blob/master/README.md

# mangOH

Base project containing apps and drivers for the mangOH hardware

## Setup

1. Download and install the appropriate toolchain for your WP module from
   [source.sierrawireless.com](https://source.sierrawireless.com)
    1. Click *AirPrime > WP Series > Your WP module > Firmware*
    1. Scroll to near the bottom of the page and follow the *Release X Components* link
    1. Download the 64-bit ToolChain
    1. Run `chmod a+x toolchain.sh` on the toolchain file (name will vary depending on module)
    1. Run the toolchain installer: `./toolchain.sh` and install to
       `/opt/swi/y22-ext_SWI9X07Y_02.14.04.00`. Alter the previous path so that it is consistent
       with the yocto version and Legato Linux distribution version.
    1. Run `ln -sf /opt/swi/y22-ext_SWI9X07Y_02.14.04.00 /opt/swi/y22-ext-wp76xx`, again modifying
       this command slightly to match the toolchain/module.
1. Yocto 1.7 based systems have a problem with their toolchain where some scripts required for
   building kernel modules aren't built. This currently affects the WP85 and WP75 release 15. To
   correct this issue, do the following.

This file has been truncated. show original

Please note that SW401 switch 3 needs to be “ON” on the mangOH_Red board in order to power up the Gyroscope/ Accelerometer.

Topic		Replies	Views
Run RedSensortoCloud with Developer Studio Legato Application Framework	1	501	November 19, 2019
Make red_wp85 gives error of missing file wifi.sinc Legato Application Framework	23	507	January 22, 2021
Legato application with MQTT protocol Legato Application Framework	1	1261	November 21, 2017
MangOH RED to backend SIM communication example Legato Application Framework	4	690	October 16, 2018
MangoH Legato Application Framework	2	537	April 25, 2016

MangOH RED SENSORS

Related topics