Hi, I’m quite new to Legato and have a ‘‘Airprime Development Kit’’ with a AR7/WP7 module. I’ve tried the steps given to configure the IP but I am unable to do so. I get the inet6 addr. but do not get the inet addr. Tried both Ethernet as well as USB. Anybody got a solution for this ??
Hi,
Does this getstarted info help?
[url]http://www.legato.io/legato-docs/15_01_1/getstarted_config_i_p.html[/url]
If you are using ethernet, it should get IP address from your router/dhcp server automatically.
If you are using USB, please follow the steps and remember to setup the IP address on your host PC too.
Hope it helps.
Thx
[quote=“lotam”]Hi,
Does this getstarted info help?
http://www.legato.io/legato-docs/15_01_1/getstarted_config_i_p.html[/quote]
Gone through this step by step and still no success.
Steps i am following…
Removing my system from LAN and connecting the kit in LAN. (or both of them should be in LAN simultaneously ??)
my Host IP is configured. when connected in LAN i am getting 2 IP’s (inet addresses): eth0 and lo
i am disconnecting the kit from LAN and only then going for USB.
please guide if i am doing something incorrectly.
Thanx.
You can always configure an inet addr by running ‘ifconfig eth0 up’ on target.
Enoch
I was trying to assign a static ip to it and got success in that… Thanx anyways 