LEC_MRC_REG_DENIED all times

1

Hi, I’m trying to connect my device (WP77XX) to RF wireless communication test set (E6621A) using USIM. When I use “cm radio” command, i have response as below,

Power : ON
Current Network Operator: USIM
Current RAT : Module not registered on network, RAT not available
Status : Registration was denied, usually because of invalid access credentials (LE_MRC_REG_DENIED)
Signal : very strong signal strength
PS : Packed switched not registered (LE_MRC_REG_NONE)

any suggestions or solutions please.

2

have you set the APN yet?

What is the following AT command response?
AT!SELRAT?
AT+CGDCONT?
AT!BAND?
AT+CPIN?
AT!GSTATUS?

3

Thanks JY
yes, APN is set.
The response to the commands are,

At!selrat?
!SELRAT: 12, GSM and LTE Only

OK
at+cgdcont?
+CGDCONT: 1,“IP”,“agilent”,“0.0.0.0”,0,0,0,0

OK
at!band?
Unknown band mask. Use AT!BAND to set band.
0000000000280180 000000000A0F189F 0000000000000000 0000000000000000

OK
at+cpin?
+CPIN: READY

OK

at!gstatus?
!GSTATUS:
Current Time: 1833 Temperature: 22
Modem Mitigate Level: 0 ModemProc Mitigate Level: 0
Reset Counter: 1 Mode: ONLINE
System mode: LTE PS state: Not attached
IMS reg state: UNKNOWN IMS mode: Not Support
IMS Srv State: UNKNOWN SMS,UNKNOWN VoIP
LTE band: B28 LTE bw: 20 MHz
LTE Rx chan: 9410 LTE Tx chan: 4294967295
LTE CA state: INACTIVE
EMM state: Deregistered Attach Needed
RRC state: RRC Idle

PCC RxM RSSI: -62 RSRP (dBm): -95
PCC RxD RSSI: -62 RSRP (dBm): -140
Tx Power: 0 TAC: 3051 (12369)
RSRQ (dB): -16 Cell ID: 082D2D0C (137178380)
SINR (dB): -3.0

OK

4

Seems this is a test SIM.
Have you tried with real network ?

5

The real sim works fine.

To connect to Agilent Wireless communication test set, I’m forced to use Agilent USIM.

6

i have never used Aglient machine with WP77 before , have you confirmed the APN is correct?

7

Hi am getting the following error, when checking the radio status in Red board, but the same sim card working fine in yellow board

root@swi-mdm9x28-wp:~# cm radio
Power: ON
Current Network Operator:
Current RAT: Module not registered on network, RAT not available
Status: Not registered but currently searching for a new operator (LE_MRC_REG_SEARCHING)
Signal: No signal strength (0)
PS: Packet Switched Not registered (LE_MRC_REG_NONE)

8

probably this is due to antenna signal not conecting well to the mangoh red board…