Hi All, Can anyone point me in the right direction… I’m trying to setup a reboot of my FX30 from within my app on certain conditions, but I haven’t been able to locate the right commands. Any help is greatly appreciated! Thanks Eddie

Does this app help? [image] Unable to ssh on eth0 (RJ45) I’m using MangOH green board with WP7603 for the testing, I want to connect USB drive using OTG cable to micro USB so I enabled SSH and PING on eth0(RJ45) in the iptable, after enabling I could ssh into the device using eth0(RJ45)…

Does this help? [image] Reset modem API function Legato Application Framework Hi. I too needed this some time ago and implemented it much like @jyijyi using faultAction: reboot in the adef file. It has the added benefit of allowing the app to run sandboxed and let the su…

Thanks! That’s exactly what I needed. Eddie

Question, I implemented “faultAction: reboot” in my apps .adef file and added exit(1); to my code. It works fine if I’m connected to the modem via USB, but if the USB is disconnected and only connected using serial (which is how it needs to function) when it reboots the modem just hangs. As soon a…

Thanks jyijyi, but that didn’t help. Let me try and describe my problem a little better. In March I was having problem with my app where it would stop communicating over the cellular network and I couldn’t recover. So I decided to have the code reboot in this scenario. I added faultAction: reboot …

I don’t see problem on my WP7607. Once I run the the wakeup_app, even I remove the USB cable, the module still wake up. After that I run the application which will run exit(1), the module can reboot successfully.

Is there a way to capture or save the log to the modem file system? Since the modem reboots when I connect the USB/SSH cable, I loose all previous logs.

How about logread -f > /home/root/log.txt

Hi @eddie435 It might be failing to reboot because the modem enters USB Suspend Mode when the USB cable is disconnected. USB autosleep is enabled by default. Try disabling it with this command: echo off > /sys/power/autosleep Note that is only temporary and it will re-enabled automatically at th…

jyijyi and raf, Thanks, both your posts help me figure out the problem. It was the USB going to low power mode. Once I applied the wakeup.app, the reboot work fine. Thank!!!

How to reboot FX30 from with code?

Legato Application Framework

jyijyi March 28, 2020, 1:01am 2

Does this help?

Topic		Replies	Views
How to auto reset app or module Legato Application Framework	5	479	April 29, 2022
Reset modem API function Legato Application Framework	6	2486	April 27, 2018
Mangoh green reboots every 5sec Legato Application Framework	3	957	December 22, 2017
Legato Reboot after install app Legato Application Framework	2	584	March 3, 2018
Disable Reboot on Errors Legato Application Framework	12	88	October 10, 2024

How to reboot FX30 from with code?

Related topics